CUSTOM

14200 E Colfax Aurora, CO 80011

303-367-9666 * Outside Colorado 800-274-5499

For custom work quotes - please email us

See something you like? Have an idea for something custom for your rig? Give us a call today. We can build to your specs or anything you see here can be built for you or modified to fit your needs!

All Pictures are the property of Off Road Ltd and cannot be duplicated without prior written consent.

1996 Ford F250 Diesel - Custom Suspension Lift with 49" Super Swamper Iroc Tires (built by Off Road Ltd)

See more of what we build

SAS Ford So you always wanted to do a straight axle swap with a driver's side driven front differential into your IFS or TTB front suspension type vehicle, but your only choice was usually an expensive custom axle, then look no further. WIB-FAB, a division of Off Road Ltd, Aurora, Colorado, has just released a new clamp-on system to allow the use of the 1979 and prior Ford 4WD Bronco and 1/2 Ton pickup front axles in those vehicles. The clamp system uses the standard C-bushings while allowing the use of heim or similar type jointed control arms. They can be ordered for use with coil-over shocks, 1980+ Ford 4WD Bronco and F150 coils or blank so you can do your own system. When used in conjunction with WIB-FAB's custom adjustable control arms, maximum articulation can be achieved as well as ease of caster and/or pinion angle adjustment without disassembly.

SYE Chevy 208/241

Slip yoke eliminator kit for the Chevy 208 and 241 transfer cases.

Complete with flanged yoke, retaining bolt, washer and shaft seal as well as all CV mounting allen head cap screws. The yoke flange will accept CVs using up to 1350 series joints. The transfer case output shaft has to be drilled and tapped.

This kit will allow the use of a rear CV drive shaft thus eliminating the vibration issue most often associated with lifted vehicles with these types of transfer cases. The conversion also provides peace of mind that should the unexpected loss of a rear drive shaft occur, one can drive out on the front drive shaft without the fear of damage to the transfer case from loss of fluid without the presence of the original slip-in yoke type drive shaft. Custom drive shafts are available upon request to complete the conversion.

Adjustable Control Arms can be built to any specifications. Email or call for more information.

Adjustable Trac Bar for 94-02 Dodge Ram (Old Body Style) with 4-6" of lift. This trac bar eliminates the tie rod ends and uses a bushing on the upper end and a heim on the lower end. Kit also comes with a new trac bar bracket.

Customer's Rigs

2000 Toyota Tundra Solid Axle Swap (Coil Over Conversion) by Off Road Ltd - 12" of Lift with 40x13.50x20 Baja Claw tires.

2003 Toyota Tacoma Winch Bumper with Skid Plate (Holds Warn 8294) Black Textured Powdercoating

Custom Roll Cage, Interior Cage, Front Bumper & Rear Bumper

Custom Front Bumper with 4 light tabs, D-rings & winch mount

1970 Chevy C20 Pickup - Custom Front Winch Bumper with Lights & Winch Mount

1997 Ford Pickup - Custom Pre-Runner Front Bumper with 4 Light tabs (Powder Coated to match)

1996 Ford F250 Diesel - Custom Coil Over Suspension Lift with 49" Iroc Tires

Chevy S-10 Pickup - Custom Bumper Tire Carrier with Gas Can Holder

Toyota Landcruiser Custom Tire Carrier/Gas Can Holder/Bumper & Front Winch Bumper with Fender Guards

1999 Toyota Tacoma 2wd Custom Front Pre-Runner Bumper with Light Mounts

1999 Toyota Tacoma 2wd Custom Pre-Runner Spare Tire Mount (35" Tire)

1986 Chevy 1/2 Ton Pickup Frame w/Custom Suspension (built @ Off Road Ltd) and Fox Remote Shocks

Custom Wrangler Rock Skids (Can be custom made to fit any other Jeep or Off Road Vehicle)

Custom Bumper with Warn Winch and Hella Lamps

Custom Tire Carrier Ford Bronco

Custom Bumper With Winch Toyota Tacoma

Custom Bumper Dodge Durango with built in grille guard and skid plates

Custom Rear Bumper Dodge Durango

We are currently looking for a 1997-2004 Dodge Durango to use to build this bumper. Since we have had such a huge request for our Durango bumper, we are offering someone a discounted price on the front bumper if you will bring us your vehicle. If interested, please contact us at orltd@yahoo.com

Custom Swing Out Tire Carrier - Ford Bronco